Surface mounted radiators

1. The design of heating piping should be reasonable so-called surface mounted, mainly referring to heating water pipes and return pipes exposed. Therefore, the design of the pipeline should be reasonable.
The installed pipelines are usually parallel-connected in two pipes, that is, the pipes connecting the return pipes to the return pipes are connected by some joints. When designing the piping, the length of the piping should be as short as possible to reduce the resistance of the water flow.

2. The outer wall and the inner wall are differentiated. The walk pipe is also divided into indoor and outdoor, like the general leveling floor, usually taken indoors. This way, the pipeline should be moved as far as possible against the corner to avoid affecting the overall appearance. Like some villas, especially single-family villas, you can consider walking outside the walls. This is mainly to avoid affecting the overall appearance and decoration style of the interior. If you go outside, the requirements for insulation are relatively high. Once the insulation is not done, the heat loss will affect the cooling effect of the interior.

3. External wall insulation should be well-recommended to do three-layer protection of the outer wall: insulation cotton, tape paper, protection box. In this way, long-term protection will be achieved to ensure that the heat loss is at a minimum and at the same time it will be aesthetically pleasing and will not affect the appearance of the exterior wall.

4. The slot plate cover should be smooth in order to prevent the pipe from being exposed. We can choose to cover it with a plastic slot board, which will be more beautiful.

5. Pipe selection Pipes can be selected after the use of aluminum plastic pipe, the interface must be handled well, otherwise it will seep for a long time. At the same time, it was stressed that the installation must be done with careful care by the master to avoid soiling the walls and furniture. Otherwise, it would have a great influence on the appearance of heating. It is also an uneconomical thing. It is best to have both temperature and style.